SCADA RS232, RS422, RS485 to TCP/IP  TCP, UDP, IP, ICMP, ARP, RARP, IP Telnet Converters and Switching Hubs. Flexible 12, 24, 48, 125 VDC and 115, 220/230 50Hz power - with high and low temperature ratings

RS232 to LAN 10/100BaseT converter The LS-101 is a LAN to Serial Device Server for Ethernet to serial applications. The Device features full serial handshake signals and 10/100BaseT network interface. LS101 makes it easy to network enable any device that has a serial port.

IPC products

	Industrial Ethernet Switches and Fiber Optic Converters The NS–105 and NS-108provides an inexpensive flexible solution for small to medium sized applications that need DC power with a DIN rail mounting and auto-negotiation for connection speed and duplex type . It is ideal for the those industrial applications.
	Serial to Ethernet Converter There are total 12 selections, six of them have display which show the IP address, and other information. This converter can bring up to 8 Serial Devices to Ethernet with its IP address. No extra programming involved. And easy to set up.
	Serial to USB Converters and Hubs It allows you to connect your serial devices to systems using a USB interface. RS232 RS422 RS485 to USB Converter
	Modbus RTU to Modbus TCP converter This programmable converter not only can do the control, but also by downloading different firmware, it is a converter for Modbus RTU to Modbus TCP.

• EtherPoll® EPL-1
   

  EtherPoll EPL-1 Single Port SCADA RS232 Serial Server "Ethernet Multi-drop Modem" - The EtherPoll supports serial interface speeds up to 230 Kbps. Since it uses the UPD/IP protocol, overhead is much lower than it would be if TCP/IP were used since there is no "session setup" or "session breakdown" with each connection. Up to 32 remote Etherpolls may be used with each host EtherPoll.

   

• Ethernet Bridge ESB-1
   

  Ethernet Bridge ESB-1 RS-232, RS422, RS485 Asynchronous Ethernet Bridge for SCADA data 12, 24, 48, 125 VDC 115VAC power and 220/230 VAC also available - The EtherSeries Bridge is 100% protocol independent. It will bridge TCP/IP, AppleTalk, DecNet, Netbui, or any protocol that can be transported over Ethernet. This makes the EtherSeries Bridge easy to set up. No configuration is necessary.

   

• EthernetPath
   

  The ETHERPATH  is a LAN to Serial Device Server for Ethernet to serial applications. The Device features full serial handshake signals and 10/100BaseT network interface. LS101 makes it easy to network enable any device that has a serial port.

   

• Modbus TCP to Modbus RTU and Modbus TCP to Modbus ASCII Gateway
   

  Modbus/TCP to Modbus RTU and or Modbus ASCII Gateway - Ether-Modbus gateway allows serial Modbus RTUs to communicate and interoperate with Modbus/TCP based controllers. Modbus has been extended to operate over Ethernet using the IP protocol suite. This gateway converts between the Modbus TCP/IP protocol and Modbus ASCII/RTU protocols transparently. The EMB-02 enables one or more MODBUS controllers to communicate with modbus ASCII/RTU based serial RTUs but it will not allow Modbus/TCP RTUs to operate with a serial MODBUS controller.

• jump to Multi-Drop Multi-Point modem

• jump to SCADA modems

• jump to VDC power modems

• jump to Industrial grade modems