Microwave Radio |
Southwest
Microwave Series 950 LAN+T1 23GHz Microwave Radio System 10Mbps Ethernet LAN plus 1.544 Mbps T1 .5 mile (800m) to 10 miles (16km) FEATURES: he Series 950 LAN+T1 Microwave Radio System is a low cost, high bandwidth, radio system capable of simultaneously transporting full bandwidth LAN traffic and T1 telephony up to 10 miles with appropriate antennas. The radio system offers the following features: The Ethernet interface of the radio system supports all 802.3 protocols and includes an AUI connection to network devices and BNC connections to the microwave unit. The T1 data interface of the radio system supports Bell Standard 100 ohm, two-wire twisted pair designed to connect to telephony and multimedia interfaces. No on-site programming is required and no additional test equipment is needed. The Series 950 LAN+T1 system provides point-to-point connections for hubs, bridges, routers and repeaters allowing full 10 Mbps Ethernet connectivity. The 950 LAN+T1 interface has been designed to connect directly to standard T1 PBX's, Channel Banks or Telecom Multiplexers without the need for additional equipment. The 950 LAN+T1 also supports full duplex Ethernet LAN operation (20 Mbps) allowing connection to full duplex devices such as Ethernet switches and adapters. Multiplexed LAN and MULTIPLE T1 access is also available for telephony and multimedia applications. The Series 950 LAN+T1 is designed for rapid installation and alignment without special tools or test equipment. Rugged, modular radio design for ease of service and field support for years of trouble free operation in harsh weather conditions. |
|
jump to related
pages
SPECIFICATIONS
General
Frequency Range
21.2 GHz - 23.6 GHz
Input Voltage
11 - 24 VDC Range
Modulation
FM
Duplex
Full Duplex
T/R Separation
1.2 GHz (Adjustable to any CCIR Rec. 637
plan)
System Gain
161 db w/2ft. Antenna
Power Consumption
35 W
Size
26 in. diameter X 14 in. depth
Weight
20 Lbs. (9 kg)
Mounting
Bracket attachment to 2.5 in. dia. pole
Emission Designator
36M0F1D
FCC Identifier
CA6950
Transmitter
Power Output
18 dBm Typical
Frequency Stability
+/-.03 %
Type
Gunn Diode Oscillator
Receiver
Sensitivity (lE-6 BER)
-65 dBm
Type
Single Conversion
Noise Figure
12 dB
IF Frequency
140 MHz
Antenna
Polarization
Vertical or Horizontal
Size
24 in. (60 cm) 2 ft.
48 in. (120 cm) 4 ft.
Gain
39 dBi - 2 ft.
44 dBi - 4 ft.
Beamwidth
1.6 degrees (3 dB)
0.8 degrees (3 db)
Operating Temperature
-30C to +55C
Storage Temperature
-40C to +65C
Relative Humidity
Up to 100%
Wind Loading
Withstand 125 mph wind
Radio Interconnections
Microwave Transceiver
1 V p-p 10 Mbps
Two RG-59 75 ohm BNC (female) connectors
Align and Power
Three position terminal strip
(12 - 22 AWG) deplugable
LAN+T1 Multiplexer Unit
Power
110 or 220 VAC input
Mechanical
1.75 in H (1RU) x 17 in W x 7 in D
5 lbs
Environmental
0 to +50C
Non condensing 95%
LAN Interconnections
AUI male (standard 15 pin D)
Full Duplex Ethernet
Switch selectable
T1 Interconnections
Six position terminal strip
100 ohm twisted pair (TX/RX)
Line Build-out
0-655 feet (switch selectable)
Radio Interconnections
RG-59 BNC (to 950 Radio)
Status and Alarms
Power, System Status, Telecom
Status LAN Status, Bit Error Rate, Local and Remote Loop Back
Options
Internal Packet Generator
Remote Diagnostic RS232 Port
Other Wireless LAN Solutions FASTWAVE 875 LAN+T1
jump to
other wireless pagescall 301-924-7400 EXT 25
or e-mail sales
sales@data-connect.com
ARC ELECTRONICS
a DCE Company
jump to ... Home Page